Crop Picture
NOTE: Do not upload any image that violates our Picture Policy. Doing so will result in the removal of the concerned image without prior notification.
概要
I have a great knowledge of Industrial Control and Automation.I got an incredible learning of Industrial Control and Automation while did a temporary job in Electro Dynamics Works. Where I did full hand hone on Delta / Siemens PLC Programming or Hardware and furthermore take a shot at HMI (Human Machine Interface). I additionally took a shot at the Inverter, Servo Drives, Sensors, Valves.I also got an experience of Power Generation while did an internship in the Power Generation Sector of Lucky Cement Limited (LCL). From where I got a great knowledge concerning with Motors, Generators, Alternators, PLC, SCADA System and Power Generation.I am also too much familiar with the Electronic Software such as WPLSOFT, STEP 7, AUTOCAD, DOPSOFT, MATLAB, PROTEUS, MULTISIM etc.
My Area of Interest is Industial Automation, Power Generation, satellite Communication, RF Communication, Circuit Designing.
项目
工作经历
INTERNEE
I invest my Two months as internee in GNSS Division of SUPARCO. Where in I worked on unique and new software, got incredible knowledge about antennas and GPS receiver, the main task that I did or learn was the GNSS signals monitoring and analyzing technique and generating report accordingly.
INTERNEE
I got an incredible learning of Industrial Control and Automation while did a temporary job in Electro Dynamic Works. Where I did full hand hone on Delta PLC or Siemens PLC Programming or Hardware and furthermore take a shot at HMI (Human machine interface). I additionally took a shot at the Inverter, Servo Drives, Sensors, Valves.
INTERNEE
I got an experience of Power Generation while did an internship in the Power Generation Sector of LUCKY CEMENT LIMITED. From where I got a great knowledge concerning with Motors, Generators, Alternators, PLC, SCADA System and Power Generation.
