Crop Picture
NOTE: Do not upload any image that violates our Picture Policy. Doing so will result in the removal of the concerned image without prior notification.
概要
I am a BS in Electronics Engineer with an aggregate of 70% marks.
- I have worked on RF amplifiers.
- DC power supplies, line drivers and modems in my industrial training project.
- I also have a good knowledge of C++, C, C#, Matlab and embedded system.
- I made DTMF controller based tele remote to manage electronics appliances through mobile phone from any place.
Some of my personal qualities which you may find useful for this role are:
- Good team worker.
- Adaptable to any kind of environment and can work under pressure.
- Good analytical and communication skills.
项目
工作经历
Inspection Engineer (HSE department)
Safety audit of CNG station all over pakistan.
To Conduct Annual inspections of CNG Stations.
To Conduct Re-Inspection of CNG Stations.
To Check the safety parameters and other parameters set by OGRA.
To Perform Calibrations / measurements of CNG dispensing Units during visit of CNG Stations
To Check Operational and conversion parameters related to equipment works / installation, Safety shut-down systems and ventilation during CNG station safety audit visit.
To collect data and pictorial evidence of each deficiency / violation observed during visit for future record
To guide the CNG Station representative / man power for the improvement of safety standard according to OGRA guidelines.
Preparation of CNG Safety audit reports.
Trainee Engineer
Worked as a Electrical supervisor.
Responsibilities.
Electrical wiring(Troubleshooting of wiring according to drawing).
Maintaing the stock of conduting(conduits,junction box,Ms box,solutions etc)
Instalment of cabel tray.
