Special Training in Dubai Sharjah
1 Done training of Building automation system and learn about following things!
* WebCtrl SOFTWARE USE FOR SCADAS and HMI.
* WebCtrl interfaces (Bacnet IP, Ethernet IP, MSTP and ARC net)
* DDC “Automated logic Controllers” (Me.Se.Zn)
* Router of Automated Logic control (LGR)
* Logic Control Programming (using different blocks)
2 Done Training of testing and commissioning of Control System
*Check all termination of Control System (sensors, actuators, valve, PID etc)
*Check System (Relays, magnetic contactor, switches, breakers, overload relays)
* Commissioned control project of HVAC.
* Commissioned HMI and SCADA

Worked as a trainee engineer control in I&MS private company Islamabad
*completed the project of Fire alarm system in (Pakistan tobacco company)
During project,
*supervised all installation of this project.
*worked on notifier controllers.
* Worked on Programming of controller.
*communication module installation (NCM, NFN, NWS, SCADA),
*smoke, heat, beam sensors.
*Done commissioning of fire alarm project

Worked as an internee Engineer in BESTWAY Cement Factory for 3months in instrumentation department. Here I have done work on the following units and equipments.
*DCS (distributed control system)
*PLC (programmable logic controller S7 200,300,400), Ladder logic (programming)
*INPUT SENSORS (Temperature sensors),RTD (PTC Resistance temperature detector) Thermister(NTC), Thermocouple,Pyrometer,Bymatalic strip
*OUTPUT ACTUATOR
i.MCC (motories control circuit),3 phase induction motors frequency drive,
*ANALYZER UNITS
Checking, calibration (cross checking)
(SOV’s (solenoid operating valve, Pump, Condenser, Filter, flow meter)
*WEIGHT FEEDER (FLOMETER)
DISPLAY (cheking, calibration (cross chek, drop test)
DC power supply, Frequency driver, Signal isolator
Got 7 days training course PLC programming from PITAC, Lahore
Final Year Project
PLC based load management by Global System Mobile (GSM)